Sew a Quilted Potholder with a Hanging Loop
A handmade quilted potholder is a useful little project for the kitchen, a housewarming gift or a relaxed weekend of sewing. It uses small fabric pieces, simple straight seams and basic quilting, making it approachable for beginners while still offering plenty of room for colour and pattern.
This version creates a heat-resistant pot holder with a practical hanging loop. Use bright prints for an Australian summer kitchen, muted linen tones for a modern home, or scraps left over from a quilt, tote bag or set of cloth napkins. With metric measurements and readily available supplies, it is easy to make at home anywhere from Perth to Hobart.
Choose Safe And Practical Materials
Select tightly woven 100% cotton for the outer layers. Quilting cotton is easy to sew and comes in a huge range of prints, including native florals, geometric designs and cheerful food-themed patterns. Avoid lightweight apparel fabric, stretchy material and synthetic satin, as these can be less suitable around heat.
For the heatproof centre, use two layers of cotton batting, insulated wadding or purpose-made heat-resistant fabric. A single layer may be too thin for handling a hot baking tray. Some insulated products have a shiny heat-reflective side; follow the manufacturer’s instructions when positioning it.
You will also need cotton thread, fabric scissors or a rotary cutter, a ruler, pins or clips and an iron. Choose firm cotton tape for the loop, or make a narrow fabric strip from a leftover scrap. A 12 cm loop is convenient for hanging the potholder from a hook beside the oven or on a kitchen rail.
Cut The Potholder Pieces
For a finished potholder measuring approximately 20 cm square, cut:
- Two 22 cm squares of cotton fabric for the front and back
- Two 22 cm squares of cotton batting or heat-resistant wadding
- One 14 cm strip of cotton fabric for the hanging loop, or a 12 cm length of cotton tape
The extra 2 cm around each square allows for a 1 cm seam allowance on every side. If you prefer a larger trivet for casserole dishes, cut 27 cm squares and keep the same construction method. A smaller 17 cm version works well as a mug mat or a holder for a saucepan handle.
Wash and dry your cotton fabric before cutting, especially if it will be used with other handmade kitchen textiles. Australian tap water and washing conditions vary between regions, and prewashing helps reduce later shrinkage. Press the fabric flat so your measurements remain accurate.
Make The Quilted Layers
Place one fabric square right side down. Add the two batting squares on top, then place the second fabric square right side up. You should have a fabric-batting-batting-fabric sandwich, with the printed sides facing outwards.
Pin through all layers, or use a few sewing clips around the edges. Mark a simple quilting design with a removable fabric pen. Straight diagonal lines are beginner-friendly: sew from one corner to the opposite corner, then repeat in the other direction to form a diamond pattern. You can also stitch parallel lines, a grid or a loose spiral.
Sew slowly through all the layers using a longer stitch length, around 3 mm. Keep the square supported on the machine bed so it does not drag or twist. If the layers shift, begin quilting from the centre and work towards the edges. Press the finished quilted panel gently, taking care not to flatten heat-reflective wadding with excessive heat.
Add The Hanging Loop And Finish The Edges
To make a fabric loop, fold the 14 cm strip in half lengthways with the right side facing out and press it. Open it, fold both long edges towards the centre crease, then fold it again and stitch close to the long edge. This creates a narrow, strong strap. If using cotton tape, simply press it in half if needed.
Fold the loop in half so the raw ends meet. Place those ends at one corner on the front of the quilted panel, with the loop pointing inwards over the potholder. Baste or stitch across the ends within the seam allowance. The loop will be pulled outwards when the binding is sewn around the edge.
Trim the quilted square so the edges are even. Bind it with pre-made bias binding, or cut four strips of cotton measuring about 5 cm wide. Sew the binding to the front, wrap it over the raw edge and stitch it neatly to the back. At the corner containing the loop, sew over the loop ends several times for extra strength.
If you are new to binding, use clips rather than pins and sew one side at a time. A contrasting binding makes the potholder look deliberately finished, while matching binding gives a calmer, minimalist result. Wash the completed item before use and inspect the seams regularly.
Personalise It For Everyday Australian Kitchens
Choose fabrics that suit the way the potholder will be used. A darker print hides marks from baking and barbecuing, while a light gingham or native botanical print suits a country kitchen. For homes in Queensland or the Northern Territory, breathable cotton is especially pleasant to handle during warm cooking weather, although the insulation still needs to be substantial.
A pair of potholders makes a thoughtful gift for a new home, university student or host family. Match them with a tea towel, wooden spoon or jar of homemade biscuits for a practical present. They are also useful for an outdoor barbecue in Adelaide, a chilly winter baking afternoon in Melbourne or a Christmas lunch on the New South Wales coast.
Local craft shops such as Spotlight and Lincraft commonly stock quilting cotton, bias binding and heat-resistant wadding. Fabric departments in larger department stores can also be useful, while weekend makers’ markets often sell small remnant bundles. Buying remnants keeps the cost down and gives you enough variety for patchwork-style potholders.
| Finished size | Cut fabric squares | Best use |
|---|---|---|
| 17 cm square | 19 cm squares | Mug mat or small saucepan |
| 20 cm square | 22 cm squares | Everyday pot holder |
| 25 cm square | 27 cm squares | Large baking tray or casserole dish |
Keep the finished potholder dry when lifting hot cookware, because moisture can conduct heat through fabric quickly. It is a protective kitchen accessory rather than a substitute for a thick oven mitt, and it should never be placed directly on a gas flame, electric element or barbecue plate.
Make a colourful pair today using cotton scraps and a few layers of batting. Hang the finished potholder where it is easy to reach, then sew another in a different print for your own kitchen or to give as a useful handmade gift.